Comments for http://www.circuit-mart.com Mon, 18 Apr 2011 10:53:36 +0100 hourly 1 http://wordpress.org/?v=3.1 Comment on Contact CircuitMart by Iris http://www.circuit-mart.com/contact-us/#comment-6 Iris Mon, 18 Apr 2011 10:53:36 +0000 http://www.circuit-mart.com/new/?page_id=19#comment-6 Dear Steve, thank you for your question. For V-cut, you could specify them in contour files, use lines same as outline. And, no extra cost for it. Best Regards! Dear Steve, thank you for your question.
For V-cut, you could specify them in contour files, use lines same as outline.
And, no extra cost for it.

Best Regards!

]]> Comment on Contact CircuitMart by Steve http://www.circuit-mart.com/contact-us/#comment-5 Steve Mon, 18 Apr 2011 09:18:34 +0000 http://www.circuit-mart.com/new/?page_id=19#comment-5 How should I specify V cuts on boards? Are there any additional cost for specifying these? How should I specify V cuts on boards? Are there any additional cost for specifying these?

]]>